• Atmel Gallery 3.1 Installation - Requirements 3.1.1 Software Tools 1. Download Atmel Studio 6 on atmel.com/atmelstudio. The Atmel ASF is included in Studio 6 and does not require a separate download. 2. Install. 3. Atmel-42330C-Atmel-ICE_User Guide-10/2016. Use the flat cable (included in some kits) to connect to a standard 50-mil Cortex header. Use the adapter board (included in some kits) to connect to a 100-mil Cortex-pinout header. Use the adapter board (included in some kits) to connect to a 20-pin 100-mil SAM header. Atmel START is an innovative online tool for intuitive, graphical configuration of embedded software projects. It lets you select and configure software components, drivers and middleware, as well as complete example projects specifically tailored to the needs of your application. The configuration stage lets you review dependencies between Getting Started Guide for ATWINC3400 W-Fi using SAM D21 Xplained Pro [USER GUIDE] Atmel-42640A-Getting-Started-Guide-for-ATWINC3400WiFi-using-SAMD21-Xplained-Pro_UserGuide_02/2016 6 6 Select an extension and proceed with download and installation: Restart Atmel Studio to take effect of the newly installed extension. 3. Restart Atmel Studio. 4. instructions, as well as the current Graphical User Interface (GUI) selections. It would be wise to create a separate project and project folder for each and every lab. To demonstrate creating a project, the first lab will be used. 1. Start AVR Studio 4 by clicking through the menus Start->Programs->Atmel AVR Tools->AVR Studio 4. The path could Programming (TPI) of all Atmel tinyAVR. ®. 8-bit microcontrollers with support. for this interface. Consult the supported devices list in the Atmel Studio User Guide for a full list of. devices and interfaces supported by this firmware release. Atmel-ICE [USER GUIDE] 42330A-MCU-07/2014. 2. As an example, we will create a simple C program for the Atmel AVR that allows the user to turn on one of the eight Light Emitting Diodes (LEDs) on the STK500 development board, by Initial guide, using Atmel Studio 4.x *** END *** b) click to program a) select HEX . Title: Microsoft Word - Getting-started-C-programming-Atmel-Studio-6 Atmel START User's Guide Contents Overview 1. Introduction 2. Requirements and Compatibility 3. Getting Started: Atmel START 4. Configuration Screens 5. TrustZone Support 6. Using Atmel START Output in External Tools 7. Content in Atmel START 8. Keyboard Shortcuts 9. Linking to Atmel START 10. Revision History The Microchip Web Site The Atmel-ICE unit requires that a front-end debugging environment Atmel Studio version 6.2 or later is installed on your computer. Atmel-ICE [USER GUIDE] 42330A-MCU-07/2014 5 The Atmel-ICE should be connected to the host computer using the USB cable provided, or a certified USB- micro cable. Atmel-ICE [USER GUIDE] 42330A-MCU-07/2014 6 2. Atmel Studio User Guide REQUIRED MATERIALS GPIO_Output.asm • µPAD v2.0 with USB A/B connector cable SUPPLEMENTAL MATERIALS • µPAD v2.0 Schematic PROCEDURE NOTE: This tutorial assumes that you already have Atmel Studio installed, and that youhave set your workspace folder to a known location . See the Atmel Studio Installation Instructions Atmel START helps you getting started with microcontroller development. It allows you to select MCU, configure software components, drivers, middleware, and example projects to tailor your embedded application in a usable and optimized manner. Once you are done you can dow