Alarms are sounded for power loss. ATS commands the generators to be started. When generators are up to speed and rated power, ATS switches to emergency generator power. Switchgear and generator software allow for automatic generator paralleling. Switchgear distributes power to designated circuits. Generator Output (Propane/NG) 8,500W 7,500W 12,500W 11,000W 14,000W 12,500W 8.5 kW 12.5 kW 14 kW ™ 50-200 Amp Automatic Transfer Switches (ATS) Load Control Module (LCM) Champion's family of automatic transfer switches (ATS) and load control module (LCM) give you options that range from 50 Amp Emergency Essentials to 200 Amp Whole House This document covers installation, operation and maintenance of the ATS-34 Automatic Transfer Switch Controller. This manual is for the use of authorized and qualified personnel only. WARNING High voltage can kill. 1.2 Product Overview We use the ATS-34 to control the second ATS in a redundant emergency ATS system. 2.5 Automatic air damper control If generator have air damper control to start, ATS panel will automatically open and close it before generator starts and stops. 3. Battery maintenance ATS panel will charge the battery automatically, charging current is 2A. 2.4 Manual Start The Analyzer Instruments ..43 Sweeps and Graphs..44 Chapter 6 The Analog Input Panel..45 Source ..45 Product Category. Product. Inverters . PWRcell Inverter - 11.4kW 3-Phase Inverter w/ CTs . . PWRcell Inverter - 7.6kW Single-Phase Inverter w/ CTs. Solar Devices . PV Link - 2500W MPPT Optimizer . . From Generator ATS 30/50 (generator command) To operate appliances from the on board generator, simply start the generator. After a 60 second delay, to let the generator stabilize the ATS will engage, transferring all 120-volt appliances connected to the ATS load terminals, to the generator output. The shoreline can remain plugged in as the ATS There are two main types of transfer switch: manual transfer switch and automatic transfer switch. The manual transfer switch allows you to manually switch the power supply from the grid to the generator by tapping the switch. However, they are unable to deal with generators or handle high-voltage loads automatically. SYK series ATS let the power supply system transfer between two power in emergency, the minimum conversion time is 0.3s to make sure the main load (emergency lighting, emergency staircase, fire-fighting system, etc) working continuously and reliably. Generator connection mode Note: 101-106 for switching power supply input and output terminals Grasp attached manual handle (left side of the operator) and turn it with thumb and fingers. 260 and 400 amp. E-design SeeFigure1-7. Insert the manual handle into the h*** in the shaft, left side of the operator. 600 and 800 amp. F-design SeeFigure1-8. Insert the manual handle into the h*** in theweight. 1000 - 3000 ampere. G-design ATS GTS Power Alpha Technologies® From Alpha Technologies (alpha.com) 020-161-B0 Rev. - 01/ 07 Installation Manual Automatic Transfer Switch (ATS) Generator Transfer Switch (GTS) Save This Manual:It contains important installation and operating instructions. Keep it in a safe place. Table of Contents