panel power system. 18 Create new file using given EDA tool to develop the layout of the regulated power supply circuit. 19 Measure dc current and dc voltage of the given circuit using node analysis through EDA simulation tool. 20 Simulate/Test half wave rectifier circuit using EDA simulation tool. 21 Use EDA tool to draw & simulate the power supply are suitable. The device is also equipped with a prefect overload and short circuit protection. It can act as both a voltage regulation power supply and a current regulation power supply. 2. Specifications 2.1 Rated operating condition and dimensions Power supply input: 220 V/110V±10% 50Hz/60Hz (switch at the back) Operating EEE 311 Electronics I Laboratory Manual Exp # 2 Assoc.Prof.Dr.TAYFUN NESİMOĞL U 1 EEE 311 Experiment #2 DC REGULATED POWER SUPPLIES I. INTRODUCTION 1. Objectives: The objective of this experiment is to become familiar with the principles of the operation of DC regulated power supplies. 2. Equipment List: 1. HP E3631A Power Supply 2. HP 34401A ELECTRONIC WORKSHOP & PCB LAB MANUAL (NEC-352) DEPARTMENT OF ELECTRONICS & COMMUNICATION ENGINEERING 27, Knowledge Park-III, Greater Noida, (U.P.) Phone : 0120-2322022 A regulated power supply is one that controls the output voltage or current to a specific value; the controlled value is held nearly constant despite variations in either The main function of the regulated power supply is to convert an unregulated alternating current (AC) to a steady direct current (DC). The RPS is used to confirm that if the input changes then the output will be stable. This power supply is also called a linear power supply, and this will allow an AC input as well as provides steady DC output. MANUAL Models 1620A/ 1621A/ 1622A/ 1623A/ 1626A/ 1627A DC REGULATED POWER SUPPLY . 2 TABLE OF CONTENTS 7. This family of power supplies provides clean and stable DC output which is most suitable for many areas including laboratory, industrial, field service, hobby, and telecommucation